netcdf twpecmwfvarX30.c1.20151001.000000 {
dimensions:
	time = UNLIMITED ; // (192 currently)
	domains = 3 ;
	levels = 137 ;
variables:
	int base_time ;
		base_time:string = " 1-Oct-2015, 00:00:00 GMT" ;
		base_time:long_name = "Base time in Epoch" ;
		base_time:units = "seconds since 1970-1-1 0:00:00 0:00" ;
	double time_offset(time) ;
		time_offset:long_name = "Time offset from base_time" ;
		time_offset:units = "seconds since 2015-10-01, 00:00:00 0:00" ;
	float domains(domains) ;
		domains:long_name = "domains" ;
		domains:units = "unitless" ;
		domains:model_resolution = "0.56 x 0.56 degrees" ;
		domains:description = "Domains over which all quantities are averaged" ;
		domains:areas_covered = "Each domain is a single point at the following coordinates" ;
		domains:area_of_domain_06 = " 130.92, -12.44 (single point)" ;
		domains:area_of_domain_28 = " 129.80, -12.44 (single point)" ;
		domains:area_of_domain_50 = " 131.06, -13.57 (single point)" ;
	float lev(levels) ;
		lev:long_name = "Level" ;
		lev:units = "unitless" ;
		lev:description = "Model Levels where Level 1 is the top full level of the model (10 hPa), level ** is the lowest full level." ;
	int idat(time) ;
		idat:long_name = "Initial Date (GMT)" ;
		idat:units = "yyyymmdd" ;
		idat:description = "The initial date of the forecast from which the data was retrieved" ;
	float itim(time) ;
		itim:long_name = "Forecast Time (GMT)" ;
		itim:units = "hours" ;
		itim:description = "The initial time of the forecast from which the data was retrieved" ;
	int vdat(time) ;
		vdat:long_name = "Verify Date (GMT)" ;
		vdat:units = "yyyymmdd" ;
		vdat:description = "The verifying date of the data meaning date and time for which it is valid" ;
	float vtim(time) ;
		vtim:long_name = "Verify Time (GMT)" ;
		vtim:units = "hours" ;
		vtim:description = "The verifying time of the data meaning date and time for which it is valid" ;
	float p(time, levels, domains) ;
		p:long_name = "pressure" ;
		p:units = "Pa" ;
	float u(time, levels, domains) ;
		u:long_name = "zonal wind component" ;
		u:units = "m/s" ;
	float v(time, levels, domains) ;
		v:long_name = "meridional wind componet" ;
		v:units = "m/s" ;
	float T(time, levels, domains) ;
		T:long_name = "Temperature" ;
		T:units = "K" ;
	float q(time, levels, domains) ;
		q:long_name = "specific humidity" ;
		q:units = "kg/kg" ;
	float l(time, levels, domains) ;
		l:long_name = "specific cloud liquid water content" ;
		l:units = "kg/kg" ;
	float i(time, levels, domains) ;
		i:long_name = "specific cloud ice content" ;
		i:units = "kg/kg" ;
	float a(time, levels, domains) ;
		a:long_name = "cloud fraction" ;
		a:units = "percent/100" ;
	float R(time, levels, domains) ;
		R:long_name = "relative humidity" ;
		R:units = "percent/100" ;
	float w(time, levels, domains) ;
		w:long_name = "omega=vertical velocity in pressure coordinates" ;
		w:units = "Pa/s" ;

// global attributes:
		:date = "Tue Nov  3 20:18:36 2015" ;
		:facility_id = "X30" ;
		:site_id = "External Data" ;
		:data_level = "c1" ;
		:data_description = "Diagnostic data derived from ECMWF model runs for ARM analysis provided by ECMWF" ;
		:data_description1 = "This file contains the model variables on each model level" ;
		:averaging_interval = "60 minutes" ;
		:averaging_interval_comment = "All data represents horizontal averages over the domains and therefore cannot easily be compared to single point measurements." ;
		:averaging_interval_comment1 = "Variables (temperature, winds, humidity, clouds etc) are valid at the time they are written into the file (as a snapshot) but they do represent averages (in time) over the turbulence spectrum, i.e. if you were to compare them to high time-resolution data at a point you do have to average over the turbulence." ;
		:reference_1 = "The ECMWF home page - http://www.ecmwf.int/" ;
		:reference_2 = "ECMWF Publications listing: http://www.ecmwf.int/pressroom/publications.html" ;
		:missing_value = -9999.f ;
		:version = "$State: xdc-ecmwf-9.0-0 $" ;
		:IDL_Version = "Coded in IDL (x86 / linux / unix / 6.2)" ;
		:command_Line = "ecmwf_ingest -i 20151001 -type var -location dar" ;
		:zeb_platform = "twpecmwfvarX30.c1" ;
		:input_files = "twpecmwfvar06X30.00.20151001.000000.raw.asc, twpecmwfvar28X30.00.20151001.000000.raw.asc, twpecmwfvar50X30.00.20151001.000000.raw.asc" ;
		:input_datastreams = "twpecmwfX30.00" ;
}