netcdf twpecmwfsfceX20.c1.20151001.000000 {
dimensions:
	time = UNLIMITED ; // (192 currently)
	domains = 2 ;
	levels = 1 ;
variables:
	int base_time ;
		base_time:string = " 1-Oct-2015, 00:00:00 GMT" ;
		base_time:long_name = "Base time in Epoch" ;
		base_time:units = "seconds since 1970-1-1 0:00:00 0:00" ;
	double time_offset(time) ;
		time_offset:long_name = "Time offset from base_time" ;
		time_offset:units = "seconds since 2015-10-01, 00:00:00 0:00" ;
	float domains(domains) ;
		domains:long_name = "domains" ;
		domains:units = "unitless" ;
		domains:model_resolution = "0.56 x 0.56 degrees" ;
		domains:description = "Domains over which all quantities are averaged" ;
		domains:areas_covered = "Except for the single point, the numbers below mark the coordinates of the northwest-southeast corners of each numbered domain" ;
		domains:area_of_domain_04 = " 166.92,  -0.49 (single point)" ;
		domains:area_of_domain_05 = " 166.10,   0.30, 167.70,  -1.30" ;
	float lev(levels) ;
		lev:long_name = "Level" ;
		lev:units = "unitless" ;
		lev:description = "Model Level is set to 1" ;
	int idat(time) ;
		idat:long_name = "Initial Date (GMT)" ;
		idat:units = "yyyymmdd" ;
		idat:description = "The initial date of the forecast from which the data was retrieved" ;
	float itim(time) ;
		itim:long_name = "Forecast Time (GMT)" ;
		itim:units = "hours" ;
		itim:description = "The initial time of the forecast from which the data was retrieved" ;
	int vdat(time) ;
		vdat:long_name = "Verify Date (GMT)" ;
		vdat:units = "yyyymmdd" ;
		vdat:description = "The verifying date of the data meaning date and time for which it is valid" ;
	float vtim(time) ;
		vtim:long_name = "Verify Time (GMT)" ;
		vtim:units = "hours" ;
		vtim:description = "The verifying time of the data meaning date and time for which it is valid" ;
	float Temperature_2m(time, levels, domains) ;
		Temperature_2m:long_name = "Temperature at 2m" ;
		Temperature_2m:units = "K" ;
	float spec_humidity(time, levels, domains) ;
		spec_humidity:long_name = "Specific humidity" ;
		spec_humidity:units = "kg/kg" ;
	float wind_u(time, levels, domains) ;
		wind_u:long_name = "10m wind u-component" ;
		wind_u:units = "m/s" ;
	float wind_v(time, levels, domains) ;
		wind_v:long_name = "10m wind v-component" ;
		wind_v:units = "m/s" ;
	float skin_temp(time, levels, domains) ;
		skin_temp:long_name = "Skin temperature" ;
		skin_temp:units = "K" ;
	float albedo(time, levels, domains) ;
		albedo:long_name = "Albedo" ;
		albedo:units = " " ;
	float down_sr(time, levels, domains) ;
		down_sr:long_name = "Downward surface solar radiation" ;
		down_sr:units = "W/m2" ;
	float down_lr(time, levels, domains) ;
		down_lr:long_name = "Downward surface longwave radiation" ;
		down_lr:units = "W/m2" ;
	float sfse(time, levels, domains) ;
		sfse:long_name = "Surface evaporation" ;
		sfse:standard_name = "water_evaporation_amount" ;
		sfse:units = "kg/m2" ;

// global attributes:
		:date = "Tue Nov  3 20:18:39 2015" ;
		:facility_id = "X20" ;
		:site_id = "External Data" ;
		:data_level = "c1" ;
		:data_description = "Diagnostic data derived from ECMWF model runs for ARM analysis provided by ECMWF" ;
		:data_description1 = "This file contains extra near surface and surface variables" ;
		:averaging_interval = "60 minutes" ;
		:averaging_interval_comment = "All data represents horizontal averages over the domains and therefore cannot easily be compared to single point measurements." ;
		:averaging_interval_comment1 = "Variables (temperature, winds, humidity, clouds etc) are valid at the time they are written into the file (as a snapshot) but they do represent averages (in time) over the turbulence spectrum, i.e. if you were to compare them to high time-resolution data at a point you do have to average over the turbulence." ;
		:data_comment = "Very small (.lt.1.E-10 for precipitation and .lt. 1.E-1 for radiation) and small negative numbers in solar radiation and precipitation are due to packing and unpacking mechanisms and do not represent model problems. " ;
		:reference_1 = "The ECMWF home page - http://www.ecmwf.int/" ;
		:reference_2 = "ECMWF Publications listing: http://www.ecmwf.int/pressroom/publications.html" ;
		:missing_value = -9999.f ;
		:version = "$State: xdc-ecmwf-9.0-0 $" ;
		:IDL_Version = "Coded in IDL (x86 / linux / unix / 6.2)" ;
		:command_Line = "ecmwf_ingest -i 20151001 -type sfce -location nauru" ;
		:zeb_platform = "twpecmwfsfceX20.c1" ;
		:input_files = "twpecmwfsfce04X20.00.20151001.000000.raw.asc, twpecmwfsfce05X20.00.20151001.000000.raw.asc" ;
		:input_datastreams = "twpecmwfX20.00" ;
}