ENA/AOS/C1 - Reprocess: reprocessing from raw data in preparation for not-yet-released b1 
level

End to end reprocessing to generate new a1 datastreams is needed so that when the 
harmonization software is released to production, we will be ready with the a1 datastreams that 
are input to the subsequent proccessing software.

• East longitude(lon)
• North latitude(lat)
• Impactor particle size cut(impactor_state)
• base_time
• time_offset
• time
• Altitude above mean sea level(alt)

ENA/AOS/C1 - Impactor stuck at 10 micron

No impactor state data saved for the entire period. Impactor was stuck at the 10 um 
position.

• Impactor particle size cut(impactor_state)

ENA/AOSMET/C1 - Missing wind speed and direction data

Wind speed and direction data are intermittently missing during this time. The sensor was 
replaced.

• Wind speed(WindSpeed)
• Wind direction, relative to true North(WindDirection)

ENA/TRACEGAS/C1 - Reduced calibration from lost instrument control

Instrument control of calibration Mass Flow Controllers ceased. Unclear why. Lack of 
calibration does not significantly compromise performance.

• Carbon monoxide (CO) mixing ratio corrected for water vapor concentration and
  calculated with nominal sensitivity correction(co_dry)
• Nitrous oxide (N2O) mixing ratio corrected for water vapor concentration and
  calculated with nominal sensitivity correction(n2o_dry)
• N2O mole fraction of during batch measurement(n2o)
• Calculated CO concentration(co)

ENA/AOSMET/C1 - Reprocessed and Corrected: Wind direction off by 80 degrees

DATA REPROCESSED and CORRECTED: 
An offset was loaded in the configuration settings of the wind sensor, so the wind 
direction was off by +80 degrees. The raw data were modified and were run through the ingest to 
correct the addressed issue. 

The reprocessed data were Archived in July 2016. Please retrieve the reprocessed data for 
use in your analysis.

You may find these data using the ARM Discovery tool at the following link:
http://www.archive.arm.gov/discovery/#v/results/s/finst::aos/fsite::ena/ffac::ena.C1 

ORIGINAL DQR CATEGORY: Red( Incorrect)

REPROCESSED and CORRECTED DATA ARCHIVED:2016-07

REPROCESS IDENTIFICATION NUMBER: RID 1425

---------------------------------------------------
--- ORIGINAL DQR DESCRIPTION ---
---------------------------------------------------

An unintentional offset was loaded in the configuration settings of the wind sensor. Wind 
direction during this time is off by +80 degrees

• Wind direction, relative to true North(WindDirection)

ENA/C1 - Reprocess: Slightly incorrect location fields

Some of the instruments are being processed with the previous "GRW-Azores" lat/lon/alt 
instead of the new "ENA-Azores" lat/lon/alt. The differences are minor, but will be 
corrected. The respective GRW and ENA lat, lon, and alt values are as follows:
 
GRW  lat = 39.0911 ;
ENA lat = 39.0916 ;
GRW  lon = -28.0297 ;
ENA  lon = -28.0257 ;
GRW  alt = 26 ;
ENA  alt = 30.48 ;

• East longitude(lon)
• North latitude(lat)
• Altitude above mean sea level(alt)

• Altitude above mean sea level(alt)
• East longitude(lon)
• North latitude(lat)

ENA/TRACEGAS/C1 - Data drop out

Instrument data drop out for an unknown reason.  No valid data.

• mass_flow_through_MFC_2
• gas_pressure
• ambient_temperature
• Nitrous oxide (N2O) mixing ratio corrected for water vapor concentration and
  calculated with nominal sensitivity correction(n2o_dry)
• set_point_for_MFC_1
• Calculated CO concentration(co)
• N2O mole fraction of during batch measurement(n2o)
• mass_flow_through_MFC_1
• set_point_for_MFC_2
• gas_temperature
• Carbon monoxide (CO) mixing ratio corrected for water vapor concentration and
  calculated with nominal sensitivity correction(co_dry)
• valve_position_MFC_2
• valve_position_MFC_1
• Water vapor mixing ratio calculated with nominal sensitivity correction(h2o)

ENA/TRACEGAS/C1 - Flow meters not operating

Flow meters were not operating so that there were no standard adds for calibration.

• Carbon monoxide (CO) mixing ratio corrected for water vapor concentration and
  calculated with nominal sensitivity correction(co_dry)
• Nitrous oxide (N2O) mixing ratio corrected for water vapor concentration and
  calculated with nominal sensitivity correction(n2o_dry)
• N2O mole fraction of during batch measurement(n2o)
• Calculated CO concentration(co)