Data Quality Reports for Session: 147356 User: koontz Completed: 01/29/2013


TABLE OF CONTENTS

DQR IDSubjectData Streams Affected
D120913.2NSA/KAZR/C1 - PLO FailurensakazrspeccmaskblxpolC1.a0, nsakazrspeccmaskcicopolC1.a0, nsakazrspeccmaskcixpolC1.a0,
nsakazrspeccmaskgecopolC1.a0, nsakazrspeccmaskgexpolC1.a0, nsakazrauxC1.a1,
nsakazrblC1.b1, nsakazrciC1.b1, nsakazrgeC1.b1, nsakazrspeccmaskblcopolC1.a0
D121218.1NSA/KAZR/C1 - Reprocess: Incorrect calibration constantsnsakazrauxC1.a1, nsakazrblC1.b1, nsakazrgeC1.b1


DQRID : D120913.2
Start DateStart TimeEnd DateEnd Time
01/29/2012200002/14/20121800
Subject:
NSA/KAZR/C1 - PLO Failure
DataStreams:nsakazrspeccmaskblxpolC1.a0, nsakazrspeccmaskcicopolC1.a0, nsakazrspeccmaskcixpolC1.a0,
nsakazrspeccmaskgecopolC1.a0, nsakazrspeccmaskgexpolC1.a0, nsakazrauxC1.a1,
nsakazrblC1.b1, nsakazrciC1.b1, nsakazrgeC1.b1, nsakazrspeccmaskblcopolC1.a0
Description:
Streaks began showing up in radar data (reflectivity, doppler velocity, spectral width, 
SNR) at semi regular intervals.  Problem was a failed 16.560 GHz Phase Lock Oscillator 
(PLO).  PLO was replaced 20120214.
Measurements:nsakazrspeccmaskgexpolC1.a0:
  • range
  • Spectral Width(spectral_width)
  • Spectrum of raw counts from spectrometer(spectra)
  • Mean Doppler velocity, clutter filtered(mean_doppler_velocity)
  • velocity_bins
  • time
  • signal_to_noise_ratio
  • Daily values of reflectivity on each grid cell(reflectivity)
  • time_offset
  • locator_mask
  • base_time

nsakazrblC1.b1:
  • time
  • signal_to_noise_ratio_copol
  • base_time
  • Reflectivity, cross-polar(reflectivity_xpol)
  • cal_constant_copol
  • signal_to_noise_ratio_xpol
  • Spectral width, copolar(spectral_width_copol)
  • Roll angle reported by tilt table(roll)
  • Pitch angle reported by tilt table(pitch)
  • Reflectivity, copolar(reflectivity_copol)
  • Mean doppler velocity, copolar(mean_doppler_velocity_copol)
  • Spectral width, cross-polar(spectral_width_xpol)
  • time_offset
  • Mean doppler velocity, cross-polar(mean_doppler_velocity_xpol)
  • cal_constant_xpol
  • rx_noise
  • range

nsakazrspeccmaskcixpolC1.a0:
  • velocity_bins
  • Spectrum of raw counts from spectrometer(spectra)
  • Mean Doppler velocity, clutter filtered(mean_doppler_velocity)
  • time
  • locator_mask
  • signal_to_noise_ratio
  • Daily values of reflectivity on each grid cell(reflectivity)
  • range
  • Spectral Width(spectral_width)
  • base_time
  • time_offset

nsakazrauxC1.a1:
  • rx_noise_ch1
  • temp_power_supply
  • rx_noise_ch2
  • processing_mode
  • time
  • rx_gain_ch1
  • rx_gain_ch2
  • power_supply_28V
  • cal_constant_ch2_xpol
  • lock_alarm_360
  • rh_local
  • pdu_status_j1_logic
  • lock_alarm_1620
  • power_supply_5V
  • power_supply_5p2V
  • temp_rf_detector
  • input_12V
  • input_5V
  • temp_lna
  • rh_antenna
  • temp_component_plate
  • tx_power
  • temp_circulator
  • temp_reverse_power
  • twta_status_state
  • cal_constant_ch2_copol
  • input_minus5V
  • temp_antenna
  • timing_mode
  • lock_alarm_16560
  • time_offset
  • temp_outside_air
  • j2_logic
  • fft_taper_type
  • fault_flags
  • temp_noise_diode
  • input_15V
  • temp_local
  • cal_constant_ch1_xpol
  • noise_source_ch2
  • spare_analog_j12_1
  • noise_source_ch1
  • temp_antenna_feedhorn
  • base_time
  • input_8V
  • lock_alarm_120
  • remote_control_enabled
  • cal_constant_ch1_copol
  • is_powered_on

nsakazrspeccmaskcicopolC1.a0:
  • Daily values of reflectivity on each grid cell(reflectivity)
  • time_offset
  • Mean Doppler velocity, clutter filtered(mean_doppler_velocity)
  • signal_to_noise_ratio
  • velocity_bins
  • Spectral Width(spectral_width)
  • locator_mask
  • range
  • Spectrum of raw counts from spectrometer(spectra)
  • time
  • base_time

nsakazrgeC1.b1:
  • time
  • cal_constant_copol
  • Mean doppler velocity, cross-polar(mean_doppler_velocity_xpol)
  • cal_constant_xpol
  • signal_to_noise_ratio_xpol
  • Mean doppler velocity, copolar(mean_doppler_velocity_copol)
  • qc_time
  • time_offset
  • Reflectivity, copolar(reflectivity_copol)
  • Spectral width, copolar(spectral_width_copol)
  • Reflectivity, cross-polar(reflectivity_xpol)
  • rx_noise
  • signal_to_noise_ratio_copol
  • base_time
  • Spectral width, cross-polar(spectral_width_xpol)
  • range

nsakazrspeccmaskblxpolC1.a0:
  • Mean Doppler velocity, clutter filtered(mean_doppler_velocity)
  • Spectral Width(spectral_width)
  • signal_to_noise_ratio
  • Spectrum of raw counts from spectrometer(spectra)
  • time_offset
  • time
  • velocity_bins
  • base_time
  • Daily values of reflectivity on each grid cell(reflectivity)
  • range
  • locator_mask

nsakazrspeccmaskgecopolC1.a0:
  • Daily values of reflectivity on each grid cell(reflectivity)
  • base_time
  • velocity_bins
  • signal_to_noise_ratio
  • Spectral Width(spectral_width)
  • Spectrum of raw counts from spectrometer(spectra)
  • time
  • locator_mask
  • range
  • Mean Doppler velocity, clutter filtered(mean_doppler_velocity)
  • time_offset

nsakazrspeccmaskblcopolC1.a0:
  • locator_mask
  • Spectral Width(spectral_width)
  • signal_to_noise_ratio
  • time_offset
  • Mean Doppler velocity, clutter filtered(mean_doppler_velocity)
  • base_time
  • Daily values of reflectivity on each grid cell(reflectivity)
  • time
  • range
  • velocity_bins
  • Spectrum of raw counts from spectrometer(spectra)

nsakazrciC1.b1:
  • Mean doppler velocity, copolar(mean_doppler_velocity_copol)
  • rx_noise
  • time
  • cal_constant_copol
  • range
  • qc_time
  • Mean doppler velocity, cross-polar(mean_doppler_velocity_xpol)
  • cal_constant_xpol
  • signal_to_noise_ratio_copol
  • signal_to_noise_ratio_xpol
  • time_offset
  • Spectral width, copolar(spectral_width_copol)
  • Reflectivity, cross-polar(reflectivity_xpol)
  • Reflectivity, copolar(reflectivity_copol)
  • Spectral width, cross-polar(spectral_width_xpol)
  • base_time


Back To Table of Contents

DQRID : D121218.1
Start DateStart TimeEnd DateEnd Time
05/12/2011000012/14/20121659
Subject:
NSA/KAZR/C1 - Reprocess: Incorrect calibration constants
DataStreams:nsakazrauxC1.a1, nsakazrblC1.b1, nsakazrgeC1.b1
Description:
The calibration constants for the modes were incorrect.  The coefficients used were

BL: -34.70 dB
GE: -18.69 dB

The correct coefficients are 

BL: -22.21dB
GE: -13.14 dB
Measurements:nsakazrblC1.b1:
  • Reflectivity, cross-polar(reflectivity_xpol)
  • cal_constant_copol
  • Reflectivity, copolar(reflectivity_copol)
  • cal_constant_xpol

nsakazrauxC1.a1:
  • cal_constant_ch1_copol
  • cal_constant_ch1_xpol
  • cal_constant_ch2_xpol
  • cal_constant_ch2_copol

nsakazrgeC1.b1:
  • cal_constant_xpol
  • Reflectivity, cross-polar(reflectivity_xpol)
  • Reflectivity, copolar(reflectivity_copol)
  • cal_constant_copol


Back To Table of Contents



END OF DATA