TWP/MWR/C1/C2 - Sun in the field of view

Every day between around noon local time (usually between 1 and 2 AM UTC time) there is an 
increase in the brightness temperatures due to the sun in the field of view of the 
radiometer.

The effect lasts less than an hour around local noon (usually between 1 and 2 AM UTC 
time).  The effect appears as a smooth increase and decrease in brightness temperature.

• tipsky23
• tipsky31

• vaptip
• liqtip
• tbskytip23
• tbskytip31

• Total liquid water along LOS path(liq)
• sky23
• 31.4 GHz sky brightness temperature(tbsky31)
• sky31
• Radiation, longwave, brightness temperature, 23.8 GHz(tbsky23)
• Total water vapor along LOS path(vap)

• sky31
• 31.4 GHz sky brightness temperature(tbsky31)
• sky23
• Total liquid water along LOS path(liq)
• Total water vapor along LOS path(vap)
• Radiation, longwave, brightness temperature, 23.8 GHz(tbsky23)

TWP/SMET/C1 - Reprocess: ORG Data has very small rainrate values

The ORG data is collected via analog signal and not digital.  Therefore, we continuously 
collect data even when no rain is occurring.  We also capture small events such as leaves, 
large bugs, dust, etc blowing through the measurement path.  Because this discrete event 
occurs quickly the value is usually captured for 1 or 2 seconds.  This value is then 
averaged to the minute producing rainrate on the order of .009 mm/hr or less.  These values 
are not indicative of rain and should be removed from the record or summing over long 
periods can bias the climate record.  We are reprocessing the data to remove these small 
values and are adjusting the collection program to remove them before ingest.

• Precipitation minimum(precip_min)
• Precipitation maximum(precip_max)
• precip_sd
• Precipitation mean(precip_mean)

TWP/SMET/C1 - Wind Speed data contain offset due to induced voltage

The marine model of the RM Young wind sensor needs twisted pair shielded cable.  The 
manufacturer did not originally supply the pigtail with twisted pair shielded cable.  Use of 
twisted pair shielded cable for the rest of the cable run to the logger was also not 
specified.  This caused an induced voltage in the wind speed line from the wind direction 
excitation.  The induced voltage varied from sensor to sensor and probably changed anytime 
the cable was replaced or parts of the wind sensor were repaired or replaced. The induced 
voltage has been seen to vary from 0.15 m/s to as much as 1.08 m/s.

• lo_spd_max
• up_spd_max
• lo_spd_vec_avg
• lo_spd_min
• lo_spd_arith_avg
• up_spd_sd
• up_spd_vec_avg
• up_spd_arith_avg
• up_spd_min
• lo_spd_sd

TWP/VCEIL/C1 - Reprocess: Incorrect serial_number and sum_backscatter fields

Attribute serial_number: In most cases, this field is not representative of the actual 
serial number of the instrument because the value did not change when an instrument changed 
locations or was replaced with a spare.
   
Variable sum_backscatter: An out-of-range condition for the "sum of detected and 
normalized backscatter" was reported as 0 instead of missing (-9999). The valid range is 0 - 
0.0999 /srad.
   
This DQR also applies to a1 level data.

• sum_backscatter