NSA/MET/C1 - Temp/RH/wind data questionable

New wind sensors and new T/RH probes were being installed during this time period.  The 
tower booms were lowered and much of the data collected were not at listed heights nor were 
the data accurate due to configurations during install.

• qc_wspd_arith_mean
• qc_rh_mean
• qc_wspd_vec_mean
• vapor_pressure_std
• Wind speed vector mean(wspd_vec_mean)
• qc_temp_mean
• temp_std
• Humidity, relative, at 2-m height, 1-min avg(rh_mean)
• dew_point_mean
• Wind speed, lower, 1-min avg(wspd_arith_mean)
• Wind direction, vector, lower, 1-min avg(wdir_vec_mean)
• qc_wdir_vec_mean
• Mean Air Temperature or Hardware Error(temp_mean)
• vapor_pressure_mean
• wdir_vec_std
• qc_vapor_pressure_mean
• qc_dew_point_mean
• trh_err_code
• dew_point_std
• rh_std

• wdir_vec_std
• qc_wspd_arith_mean
• qc_temp_mean
• trh_err_code
• Wind speed, lower, 1-min avg(wspd_arith_mean)
• qc_wdir_vec_mean
• dew_point_mean
• Mean Air Temperature or Hardware Error(temp_mean)
• temp_std
• Wind speed vector mean(wspd_vec_mean)
• Humidity, relative, at 2-m height, 1-min avg(rh_mean)
• dew_point_std
• rh_std
• qc_rh_mean
• Wind direction, vector, lower, 1-min avg(wdir_vec_mean)
• vapor_pressure_mean
• vapor_pressure_std
• qc_wspd_vec_mean
• qc_dew_point_mean
• qc_vapor_pressure_mean

NSA/MET/C1 - Wind data intermittent

There was a loose wire on the serial data multiplexer causing the wind data to become 
missing during high wind situations.  The high winds caused the enclosure to vibrate making 
the connection intermittent.

• Wind speed, lower, 1-min avg(wspd_arith_mean)
• qc_wspd_arith_mean
• qc_wspd_vec_mean
• Wind direction, vector, lower, 1-min avg(wdir_vec_mean)
• qc_wdir_vec_mean
• Wind speed vector mean(wspd_vec_mean)
• wdir_vec_std

• wdir_vec_std
• qc_wspd_arith_mean
• Wind direction, vector, lower, 1-min avg(wdir_vec_mean)
• qc_wspd_vec_mean
• Wind speed, lower, 1-min avg(wspd_arith_mean)
• qc_wdir_vec_mean
• Wind speed vector mean(wspd_vec_mean)

NSA/MET/C1 - Met data incorrect during calibration

All met data from the tower booms (temp, RH, winds and derived variables) were incorrect 
due to the booms being lowered from their measurement heights.  Additionally, the 
scaffolding was located directly adjacent to the booms affecting the wind field and the Temp/RH 
data.

• qc_wspd_arith_mean
• qc_rh_mean
• qc_wspd_vec_mean
• vapor_pressure_std
• Wind speed vector mean(wspd_vec_mean)
• qc_temp_mean
• temp_std
• qc_time
• Humidity, relative, at 2-m height, 1-min avg(rh_mean)
• dew_point_mean
• Wind speed, lower, 1-min avg(wspd_arith_mean)
• Wind direction, vector, lower, 1-min avg(wdir_vec_mean)
• qc_wdir_vec_mean
• Mean Air Temperature or Hardware Error(temp_mean)
• vapor_pressure_mean
• wdir_vec_std
• qc_vapor_pressure_mean
• qc_dew_point_mean
• trh_err_code
• dew_point_std
• rh_std

• wdir_vec_std
• qc_wspd_arith_mean
• qc_temp_mean
• trh_err_code
• Wind speed, lower, 1-min avg(wspd_arith_mean)
• qc_wdir_vec_mean
• dew_point_mean
• Mean Air Temperature or Hardware Error(temp_mean)
• temp_std
• Wind speed vector mean(wspd_vec_mean)
• Humidity, relative, at 2-m height, 1-min avg(rh_mean)
• dew_point_std
• rh_std
• qc_rh_mean
• Wind direction, vector, lower, 1-min avg(wdir_vec_mean)
• vapor_pressure_mean
• vapor_pressure_std
• qc_wspd_vec_mean
• qc_dew_point_mean
• qc_vapor_pressure_mean

NSA/MET/C1 - 2m RH values incorrect

The new t/rh probe installed during annual calibrations and checks began to exhibit 
readings that were biased high compared to the Chilled Mirror Hygrometer.  In high RH 
conditions the sensor would consistently report RH values in excess of 105%.  Comparisons to the 
other tower levels also suggested that the 2m level RH data is suspect.

• Humidity, relative, at 2-m height, 1-min avg(rh_mean)
• dew_point_mean
• qc_rh_mean
• vapor_pressure_std
• vapor_pressure_mean
• qc_dew_point_mean
• dew_point_std
• rh_std

• rh_std
• qc_rh_mean
• vapor_pressure_mean
• vapor_pressure_std
• dew_point_mean
• qc_dew_point_mean
• Humidity, relative, at 2-m height, 1-min avg(rh_mean)
• dew_point_std
• qc_vapor_pressure_mean

NSA/TWR/C2  - Reprocess: 5m vapor pressure incorrect at temps above freezing

The 5m Vapor pressure calculation was in error for temperatures equal to or above 0C.  The 
2m Dew Point values were used for calculating the Vapor Pressure when the temps were 
equal to or above 0C.  

The following formula should be used to correct the data: 
 VP5M = (6.1365 (EXP((17.502*DP5M)/(240.97+DP5M))))*0.1.

• qc_vapor_pressure_mean
• vapor_pressure_std
• vapor_pressure_mean

NSA/TWR/C2 - 5m RH values Incorrect

The 5m RH sensor cap had fallen off and caused the 5m RH readings to be incorrect during 
times of high RH (>95%).

• Humidity, relative, at 2-m height, 1-min avg(rh_mean)
• rh_std
• qc_rh_mean

NSA/TWR/C1 - 40m T/RH Sensor Failure

40m RH data were very noisy after tower maintenance.  Following system re-boot, RH data 
were too high. Sensor was replaced.

• dew_point_mean
• qc_dew_point_mean
• rh_std
• qc_rh_mean
• vapor_pressure_mean
• vapor_pressure_std
• dew_point_std
• Humidity, relative, at 2-m height, 1-min avg(rh_mean)
• qc_vapor_pressure_mean

NSA/TWR/C1 - 40m and 20m Data Incorrect

A power distribution problem required us to shut down power to the 40m level.  All T/RH 
were missing and the 40m wind sensor did not have heat to remove any ice build up.  All 
wind data from the 40m level should be viewed critically before use.  The 20m T/RH sensor 
was power spike when the problem occurred causing this sensor to become erratic.  
See D100302.2 for the continuation of the 40m problem.

• wdir_vec_std
• rh_std
• qc_rh_mean
• qc_wspd_arith_mean
• qc_temp_mean
• Wind direction, vector, lower, 1-min avg(wdir_vec_mean)
• vapor_pressure_mean
• vapor_pressure_std
• qc_wspd_vec_mean
• trh_err_code
• Wind speed, lower, 1-min avg(wspd_arith_mean)
• qc_wdir_vec_mean
• dew_point_mean
• qc_dew_point_mean
• Mean Air Temperature or Hardware Error(temp_mean)
• temp_std
• Wind speed vector mean(wspd_vec_mean)
• Humidity, relative, at 2-m height, 1-min avg(rh_mean)
• dew_point_std
• qc_vapor_pressure_mean

NSA/TWR/C1 - 40m level data incorrect

A power distribution problem required us to turn off the 50V DC power to the 40m level.  
This shutdown the T/RH probe and the heating of the ultrasonic sensor.  The wind data is 
useful at times when there is no icing present.  This DQR is a follow on to D091201.2 that 
was closed when the 20m level T/RH probe was replaced.

• wdir_vec_std
• rh_std
• Wind direction, vector, lower, 1-min avg(wdir_vec_mean)
• vapor_pressure_mean
• vapor_pressure_std
• trh_err_code
• Wind speed, lower, 1-min avg(wspd_arith_mean)
• dew_point_mean
• Mean Air Temperature or Hardware Error(temp_mean)
• temp_std
• Wind speed vector mean(wspd_vec_mean)
• Humidity, relative, at 2-m height, 1-min avg(rh_mean)
• dew_point_std