HFE/MWRHF/M1 - 150-GHz data drop out

The sky brightness temperature at 150 GHz (tbsky150) dropped to zero at 12:29 GMT on 
20080804 and stayed flat lined until 23:40 GMT on 20081002.

• Sky brightness temperature (150 GHz)(tbsky150)

HFE/MWRHF/M1 - Frosting/Condensation

The heater module was installed on 6/4/2008. Before this time there is condensation on the 
window during night time and early morning. On 8/18 the heater appears to have failed 
and nighttime condensation re-occurred on the radome during conditions of high humidity.

Users can identify the segments affected by observing a smooth steady increase in the 
brightness temperature (BT). BT values can increase to more than 250 K and then smoothly 
decrease. The RH during these events is usually above 70%. Users should disregard data 
affected by condensation.

• Sky brightness temperature (90 GHz)(tbsky90)
• Sky brightness temperature (150 GHz)(tbsky150)

HFE/MWRHF/M1 - Calibration updates

The MWRHF calibration algorithm updates the calibration parameters every time a new 
successful tip curve is acquired. 

This results in small jumps (1-2 K) in the brightness temperatures each time calibration 
is updated. During times of frequent calibrations the data appear discontinuous with short 
data segments interrupted by small jumps.

• Sky brightness temperature (90 GHz)(tbsky90)
• Sky brightness temperature (150 GHz)(tbsky150)

HFE/MWRHF/M1 - Rain sensor failure

The rain sensor failed and the rain flag was always on.  When the rain flag is on the 
radiometer does not perform tip curves. The rain sensor was replaced 8/4.

• Rain flag(rain_flag)

HFE/MWRHF/M1 - Elevated noise in 150 GHz data

The noise level of the 150 GHz channel was about 4 times higher than expected, likely due 
to failure of the noise diode.  Disregard the 150 GHz data.

• Sky brightness temperature (150 GHz)(tbsky150)