Data Quality Reports for Session: 132120 User: kjohnson Completed: 12/09/2010


TABLE OF CONTENTS

DQR IDSubjectData Streams Affected
D080428.2TWP/SMET/C1 - Reprocess: ORG Data has very small rainrate valuestwpsmet60sC1.b1
D081210.14TWP/MMCR/C1 - Reduced sensitivity due to LNA failuretwpmmcrmomC1.b1, twpmmcrspecmomC1.a0
D100215.4TWP/VCEIL/C1 - Reprocess: Incorrect serial_number and sum_backscatter fieldstwpvceil25kC1.b1


DQRID : D080428.2
Start DateStart TimeEnd DateEnd Time
08/01/2004000006/30/20102359
Subject:
TWP/SMET/C1 - Reprocess: ORG Data has very small rainrate values
DataStreams:twpsmet60sC1.b1
Description:
The ORG data is collected via analog signal and not digital.  Therefore, we continuously 
collect data even when no rain is occurring.  We also capture small events such as leaves, 
large bugs, dust, etc blowing through the measurement path.  Because this discrete event 
occurs quickly the value is usually captured for 1 or 2 seconds.  This value is then 
averaged to the minute producing rainrate on the order of .009 mm/hr or less.  These values 
are not indicative of rain and should be removed from the record or summing over long 
periods can bias the climate record.  We are reprocessing the data to remove these small 
values and are adjusting the collection program to remove them before ingest.
Measurements:twpsmet60sC1.b1:
  • Precipitation minimum(precip_min)
  • Precipitation maximum(precip_max)
  • precip_sd
  • Precipitation mean(precip_mean)


Back To Table of Contents

DQRID : D081210.14
Start DateStart TimeEnd DateEnd Time
12/10/2008000002/04/20091515
Subject:
TWP/MMCR/C1 - Reduced sensitivity due to LNA failure
DataStreams:twpmmcrmomC1.b1, twpmmcrspecmomC1.a0
Description:
The low noise amplifier (LNA) failed resulting in a loss of approximately 26 dB of 
receiver gain and sensitivity.

The reflectivity values should be correct but sensitivity is reduced.
Measurements:twpmmcrspecmomC1.a0:
  • Rx290KLevel
  • RxGain
  • Power
  • NumFFT
  • MinimumDetectableReflectivity
  • SkyNoiseLevel
  • DCFilterONOFF
  • WindowingONOFF
  • RadarConstant
  • Heights
  • AvgNoiseLevel
  • InterPulsePeriod
  • lon
  • NyquistVelocity
  • PulseWidth
  • NumCodeBits
  • CalibrationConstant
  • Cloud, reflectivity, at altitude(Reflectivity)
  • Azimuth
  • GateSpacing
  • NumCoherentIntegrations
  • ReceiverNumber
  • CircularDepolarizationRatio
  • ModeDescription
  • Elevation
  • NumHeights
  • ClutterHeight
  • ReceiverMode
  • CalCheckTime
  • DataQualityStatus
  • RangeCorrectedPower
  • MMCR Mean Doppler Velocity(MeanDopplerVelocity)
  • SignalToNoiseRatio
  • NoiseLevel
  • MMCR Spectral Width(SpectralWidth)
  • alt
  • lat
  • CalCheckLevel
  • NumSpectralAverages
  • RxCalTimeStamp
  • NumReceivers
  • ModeNum
  • base_time
  • StartGateDelay
  • time_offset
  • Cloud, doppler spectrum, at altitude, 8-mm radar(Spectra)

twpmmcrmomC1.b1:
  • MMCR Mean Doppler Velocity(MeanDopplerVelocity)
  • time
  • WindowingONOFF
  • lon
  • MMCR Spectral Width(SpectralWidth)
  • time_offset
  • Cloud, reflectivity, at altitude(Reflectivity)
  • ReceiverMode
  • DCFilterONOFF
  • SkyNoiseLevel
  • ReceiverNumber
  • heights
  • NumFFT
  • NyquistVelocity
  • TimeAvg
  • RadarConstant
  • ClutterHeight
  • NumHeights
  • RangeCorrectedPower
  • MinimumDetectableReflectivity
  • ModeNum
  • CalCheckLevel
  • Power
  • base_time
  • PulseWidth
  • lat
  • InterPulsePeriod
  • Rx290KLevel
  • DataQualityStatus
  • RxCalTimeStamp
  • NumSpectralAverages
  • CircularDepolarizationRatio
  • NumCoherentIntegrations
  • SignalToNoiseRatio
  • PeakTransmittedPowerAvg
  • AvgNoiseLevel
  • NoiseLevel
  • CalCheckTime
  • ModeDescription
  • GateSpacing
  • RxGain
  • StartGateDelay
  • alt
  • NumCodeBits
  • TWTStatusCode
  • NumReceivers


Back To Table of Contents

DQRID : D100215.4
Start DateStart TimeEnd DateEnd Time
10/11/1996000010/31/20092359
Subject:
TWP/VCEIL/C1 - Reprocess: Incorrect serial_number and sum_backscatter fields
DataStreams:twpvceil25kC1.b1
Description:
Attribute serial_number: In most cases, this field is not representative of the actual 
serial number of the instrument because the value did not change when an instrument changed 
locations or was replaced with a spare.
   
Variable sum_backscatter: An out-of-range condition for the "sum of detected and 
normalized backscatter" was reported as 0 instead of missing (-9999). The valid range is 0 - 
0.0999 /srad.
   
This DQR also applies to a1 level data.
Measurements:twpvceil25kC1.b1:
  • sum_backscatter


Back To Table of Contents



END OF DATA