NSA/TSI/C1 - Mirror frozen

The mirror was not rotating so the shadowband was not masking the sun. This appears to 
have been caused by snow that was melted by the mirror heater and then re-frozen by high, 
cold winds.

• region.zenith.count.opaque
• count.opaque
• Cloud amount, thin (percent)(percent.thin)
• count.thin
• region.horizon.count.opaque
• region.sun.count
• region.horizon.count.thin
• region.horizon.count
• region.zenith.count
• region.sun.count.thin
• region.zenith.count.thin
• region.sun.count.opaque
• count.sky
• Cloud amount, opaque (percent)(percent.opaque)

• Cloud decision images, Total Sky Imager, PNG format(png)

• JPEG data stream - documentation not yet available

NSA/VCEIL/C1 - Degraded window

The ceilometer continuously gave warnings for window contamination because the window had 
deteriorated. Cloud base height detection did not appear to be significantly affected. 
The window conditioner was replaced on 8/11/09 but this did not clear the warning. The 
instrument was replaced.

• Third cloud base height(third_cbh)
• alt_highest_signal
• Second lowest cloud base height(second_cbh)
• status_flag
• sum_backscatter
• Lowest cloud base height detected.(first_cbh)
• Backscatter(backscatter)
• background_light
• status_string
• Vertical visibility(vertical_visibility)
• window_contamination

NSA/VCEIL/C1/C2 - Reprocess: Incorrect serial_number and sum_backscatter fields

Attribute serial_number: In most cases, this field is not representative of the actual 
serial number of the instrument because the value did not change when an instrument changed 
locations or was replaced with a spare.
   
Variable sum_backscatter: An out-of-range condition for the "sum of detected and 
normalized backscatter" was reported as 0 instead of missing (-9999). The valid range is 0 - 
0.0999 /srad.
   
This DQR also applies to a1 and b1 level data collected prior to the begin date.

• sum_backscatter

• sum_backscatter

NSA/VCEIL/C1 - Small gaps in data

When the ceilometer was replaced, small gaps in the netCDF files occurred due to the 
presence of '?' characters in the backscatter and header records of the raw data that could 
not be ingested. It is unknown whether this was caused by a poor CPU board or 
incompatibilities with the computer configuration (hyper-threading). The problem was corrected when 
the instrument and computer were both replaced. 

During this period, approximately 3% of data are missing each hour due to this problem.

• Third cloud base height(third_cbh)
• alt_highest_signal
• receiver_sensitivity
• laser_temperature
• Second lowest cloud base height(second_cbh)
• Lowest cloud base height detected.(first_cbh)
• Vertical visibility(vertical_visibility)
• tilt_angle
• time_offset
• measurement_parameters
• status_flag
• sum_backscatter
• range
• base_time
• Backscatter(backscatter)
• status_string
• background_light
• window_contamination
• laser_pulse_energy
• detection_status