NIM/SKYRAD/M1 - IRTs do not agree with AERI

Since deployment at PYE, and then at NIM, the AMF SKYRAD IRT measured about 10K higher sky 
temperatures than the AERI and the MWRP IRT measureed about 20K higher than the AERI.  
Several actions were taken to diagnose the problem including confirming the correct 
configuration of the IRTs and data logger, cleaning the mirror and lens, and replacing the mirror.

After several days of rain beginning 6/2/2006, the three instruments came into agreement. 
It is unknown whether this was a problem with the AERI, MWRP-IRT or SKYRAD-IRT.

• sky_ir_temp_min
• Temperature, Sky Infra-Red(sky_ir_temp)
• sky_ir_temp_max

NIM/MET/M1 - ORG Data Underestimated Precipitation

The ORG underestimated precipitation by about 38% during the entire NIM deployment.  No 
troubleshooting technique or replacement of gage was successful in correcting the problem.

• precip_rate_min
• org_carrier_mean
• Rain, surface, 1-min avg(precip_rate_mean)
• precip_rate_max
• precip_rate_sd

NIM/MET/M1 - Reprocess: ORG Data has very small rainrate values

The ORG data is collected via analog signal and not digital.  Therefore, we
   continuously collect data even when no rain is occurring.  We also capture
   small events such as leaves, large bugs, dust, etc blowing through the
   measurement path.  Because this discrete event occurs quickly the value is
   usually captured for 1 or 2 seconds.  This value is then averaged to the
   minute producing rainrate on the order of .009 mm/hr or less.  These values
   are not indicative of rain and should be removed from the record or summing
   over long periods can bias the climate record.  We are reprocessing the data
   to remove these small values and are adjusting the collection program to
   remove them before ingest.

• precip_rate_min
• Rain, surface, 1-min avg(precip_rate_mean)
• precip_rate_max
• precip_rate_sd

NIM/MET/M1 - Wind Speed data contain offset due to induced voltage

The marine model of the RM Young wind sensor needs twisted pair shielded cable.  The 
manufacturer did not originally supply the pigtail with twisted pair shielded cable.  Use of 
twisted pair shielded cable for the rest of the cable run to the logger was also not 
specified.  This caused an induced voltage in the wind speed line from the wind direction 
excitation.  The induced voltage varied from sensor to sensor and probably changed anytime 
the cable was replaced or parts of the wind sensor were repaired or replaced. The induced 
voltage has been seen to vary from 0.15 m/s to as much as 1.08 m/s.

• Wind speed, lower, 1-min avg(wind_spd_arith_avg)
• Vector-averaged Wind Speed(wind_spd_vec_avg)
• wind_spd_arith_min
• wind_spd_arith_max
• wind_spd_arith_sd