TWP/SMET/C3 - Reprocess: Tipping bucket rain gauge added

A tipping bucket rain gauge was added to the SMET suite of instruments effective 20060926. 
 Two new variables (count and rain amount) were added at the end of the twpsmet60sC1.b1 
datastream.  When reprocessing of this datastream occurs these variables will be added 
with -9999 (missing) as the value for dates prior to gauge installation.

• base time(base_time)

TWP/SMET/C3 - Wind Speed data contain offset due to induced voltage

The marine model of the RM Young wind sensor needs twisted pair shielded cable.  The 
manufacturer did not originally supply the pigtail with twisted pair shielded cable.  Use of 
twisted pair shielded cable for the rest of the cable run to the logger was also not 
specified.  This caused an induced voltage in the wind speed line from the wind direction 
excitation.  The induced voltage varied from sensor to sensor and probably changed anytime 
the cable was replaced or parts of the wind sensor were repaired or replaced. The induced 
voltage has been seen to vary from 0.15 m/s to as much as 1.08 m/s.

• Upper sensor, wind speed vector average(up_spd_vec_avg)
• Lower sensor, wind speed vector average(lo_spd_vec_avg)
• Lower sensor, wind speed standard deviation(lo_spd_sd)
• Lower sensor, wind speed minimum(lo_spd_min)
• Upper sensor, wind speed maximum(up_spd_max)
• Upper sensor, wind speed minimum(up_spd_min)
• Upper sensor, wind speed standard deviation(up_spd_sd)
• Lower sensor, wind speed arithmetic average(lo_spd_arith_avg)
• Upper sensor, wind speed arithmetic average(up_spd_arith_avg)
• Lower sensor, wind speed maximum(lo_spd_max)

TWP/SMET/C3 - Reprocess: Temperature data biased low

Due to a datalogger problem, the temperature data were biased low by 2.13 degrees C.

The data will be reprocessed.

• Std Dev of Air Temperature(temp_sd)
• Mean Air Temperature or Hardware Error(temp_mean)