TWP/SMET/C2 - Negative rainfall rates

Due to limitations of the Zeno dataloggers all voltage measurements
from the optical rain gauge (ORG) were converted to rainfall rates. 
This resulted in negative values for rain rates.  Any value below
0.10 mm/hr should be considered to be 0 mm/hr.  New dataloggers 
alleviated this problem.

• Precipitation maximum(precip_max)
• Precipitation mean(precip_mean)
• precipitation minimum(precip_min)
• Precipitation standard deviation(precip_sd)

TWP/SMET/C2 - Reprocess: Barometric pressure units change

Barometric pressure data during this time period is reported in hPa.  After this time, the 
data have been converted to kPa to standardize the measurement units among ARM sites and 
to conform to accepted standard units determined by the scientific community.

• Barometric Pressure(atmos_pressure)

TWP/SMET/C2 - Reprocess: Tipping bucket rain gauge added

A tipping bucket rain gauge was added to the TWP.C2 SMET suite of instruments on 20061129. 
Effective 20060926, two new variables (count and rain amount) were added to the end of 
the twpsmet60sC2.b1 datastream.  Between 9/26 and 11/29, the data for these two variables 
are filled with zeros.  Users should not use the data during this period as the zeros are 
not representative of the rain fall at the site.  When reprocessing of this datastream 
occurs these variables will be added for the 19981021-20060926 and data from 
19981021-20061129 will be filled with -9999 (missing).

• base time(base_time)

TWP/SMET/C2 - Wind Speed data contain offset due to induced voltage

The marine model of the RM Young wind sensor needs twisted pair shielded cable.  The 
manufacturer did not originally supply the pigtail with twisted pair shielded cable.  Use of 
twisted pair shielded cable for the rest of the cable run to the logger was also not 
specified.  This caused an induced voltage in the wind speed line from the wind direction 
excitation.  The induced voltage varied from sensor to sensor and probably changed anytime 
the cable was replaced or parts of the wind sensor were repaired or replaced. The induced 
voltage has been seen to vary from 0.15 m/s to as much as 1.08 m/s.

• Upper sensor, wind speed vector average(up_spd_vec_avg)
• Upper sensor, wind speed minimum(up_spd_min)
• Lower sensor, wind speed minimum(lo_spd_min)
• Upper sensor, wind speed maximum(up_spd_max)
• Lower sensor, wind speed arithmetic average(lo_spd_arith_avg)
• Lower sensor, wind speed maximum(lo_spd_max)
• Lower sensor, wind speed vector average(lo_spd_vec_avg)
• Lower sensor, wind speed standard deviation(lo_spd_sd)
• Upper sensor, wind speed arithmetic average(up_spd_arith_avg)
• Upper sensor, wind speed standard deviation(up_spd_sd)