TWP/SMET/C3 - Reprocess: Barometric pressure units change

Barometric pressure data during this time period is reported in hPa.  After this time, the 
data have been converted to kPa to standardize the measurement units among ARM sites and 
to conform to accepted standard units determined by the scientific community.

• Barometric Pressure(atmos_pressure)

TWP/SMET/C3 - Reprocess: Tipping bucket rain gauge added

A tipping bucket rain gauge was added to the SMET suite of instruments effective 20060926. 
 Two new variables (count and rain amount) were added at the end of the twpsmet60sC1.b1 
datastream.  When reprocessing of this datastream occurs these variables will be added 
with -9999 (missing) as the value for dates prior to gauge installation.

• base time(base_time)

TWP/SMET/C3 - Missing data

Data are missing and unrecoverable.

• time(time)
• lat(lat)
• Lower sensor, wind speed minimum(lo_spd_min)
• Time offset of tweaks from base_time(time_offset)
• Precipitation maximum(precip_max)
• Battery Voltage(internal_voltage)
• Logger panel temperature(logger_temp)
• Lower sensor, wind direction standard deviation(lo_dir_sd)
• precipitation minimum(precip_min)
• Upper sensor, wind speed maximum(up_spd_max)
• Tipping bucket raingauge total(tbrg_total)
• Mean Air Temperature or Hardware Error(temp_mean)
• Vapor pressure mean(vappress_mean)
• Upper sensor, wind direction standard deviation(up_dir_sd)
• Lower sensor, wind speed arithmetic average(lo_spd_arith_avg)
• Barometric Pressure(atmos_pressure)
• Lower sensor, wind speed standard deviation(lo_spd_sd)
• Vapor pressure standard deviation(vappress_sd)
• Mean Relative Humidity(relh_mean)
• Lower sensor, wind speed maximum(lo_spd_max)
• Upper sensor, wind speed arithmetic average(up_spd_arith_avg)
• Lower sensor, wind speed vector average(lo_spd_vec_avg)
• Upper sensor, wind direction vector average(up_dir_vec_avg)
• Std Dev of Relative Humidity or Hardware Error Code(relh_sd)
• Precipitation mean(precip_mean)
• Lower sensor, wind direction vector average(lo_dir_vec_avg)
• base time(base_time)
• Dummy altitude for Zeb(alt)
• Precipitation standard deviation(precip_sd)
• lon(lon)
• Upper sensor, wind speed minimum(up_spd_min)
• Tipping bucket raingauge count total(tbrg_count_total)
• Upper sensor, wind speed vector average(up_spd_vec_avg)
• Std Dev of Air Temperature(temp_sd)
• Upper sensor, wind speed standard deviation(up_spd_sd)

TWP/SMET/C3 - Wind Speed data contain offset due to induced voltage

The marine model of the RM Young wind sensor needs twisted pair shielded cable.  The 
manufacturer did not originally supply the pigtail with twisted pair shielded cable.  Use of 
twisted pair shielded cable for the rest of the cable run to the logger was also not 
specified.  This caused an induced voltage in the wind speed line from the wind direction 
excitation.  The induced voltage varied from sensor to sensor and probably changed anytime 
the cable was replaced or parts of the wind sensor were repaired or replaced. The induced 
voltage has been seen to vary from 0.15 m/s to as much as 1.08 m/s.

• Upper sensor, wind speed maximum(up_spd_max)
• Lower sensor, wind speed minimum(lo_spd_min)
• Lower sensor, wind speed standard deviation(lo_spd_sd)
• Lower sensor, wind speed maximum(lo_spd_max)
• Upper sensor, wind speed arithmetic average(up_spd_arith_avg)
• Lower sensor, wind speed vector average(lo_spd_vec_avg)
• Upper sensor, wind speed minimum(up_spd_min)
• Lower sensor, wind speed arithmetic average(lo_spd_arith_avg)
• Upper sensor, wind speed vector average(up_spd_vec_avg)
• Upper sensor, wind speed standard deviation(up_spd_sd)