TWP/SMET/C3 - Reprocess: Tipping bucket rain gauge added

A tipping bucket rain gauge was added to the SMET suite of instruments effective 20060926. 
 Two new variables (count and rain amount) were added at the end of the twpsmet60sC1.b1 
datastream.  When reprocessing of this datastream occurs these variables will be added 
with -9999 (missing) as the value for dates prior to gauge installation.

• base time(base_time)

TWP/VCEIL/C3 - standard instrument installed

A spare ceilometer without the tropics window option was installed. The manufacturer 
recommends the tropics window be used at +/- 25 deg lattitude to prevent direct solar 
radiation into the laser optics when the instrument pointed at zenith. No significant signal 
degradation is apparent during the autumnal equinox but, as a precaution, the unit was 
replaced with the original with a tropics window.

• Percentage of nominal factory setting (0 to 999%)(laser_pulse_energy)
• Vertical visibility(vertical_visibility)
• Aerosol backscatter coefficient at 355 nm(backscatter)
• Backscatter sum(sum_backscatter)
• Laser temperature(laser_temperature)
• Millivolts at internal ADC input (0 to 2500)(background_light)

TWP/MMCR/C3 - Reprocess:   Height Error

A timing error was found in the PIRAQ MMCR's.  It resulted in recorded heights being too 
high for each radar mode by the following amounts: 
   Mode 1: 24.8756 m too high
   Mode 2: 25.6249 m too high
   Mode 3: 33.1176 m too high
   Mode 4: 33.1176 m too high
Range gate spacing was not affected.

• Height of Center of Each Range Bin(Heights)

• Raw data stream - documentation not supported(raw)

• Array of heights for each power(heights)

TWP/SMET/C3 - Wind Speed data contain offset due to induced voltage

The marine model of the RM Young wind sensor needs twisted pair shielded cable.  The 
manufacturer did not originally supply the pigtail with twisted pair shielded cable.  Use of 
twisted pair shielded cable for the rest of the cable run to the logger was also not 
specified.  This caused an induced voltage in the wind speed line from the wind direction 
excitation.  The induced voltage varied from sensor to sensor and probably changed anytime 
the cable was replaced or parts of the wind sensor were repaired or replaced. The induced 
voltage has been seen to vary from 0.15 m/s to as much as 1.08 m/s.

• Upper sensor, wind speed maximum(up_spd_max)
• Lower sensor, wind speed minimum(lo_spd_min)
• Lower sensor, wind speed standard deviation(lo_spd_sd)
• Lower sensor, wind speed maximum(lo_spd_max)
• Upper sensor, wind speed arithmetic average(up_spd_arith_avg)
• Lower sensor, wind speed vector average(lo_spd_vec_avg)
• Upper sensor, wind speed minimum(up_spd_min)
• Lower sensor, wind speed arithmetic average(lo_spd_arith_avg)
• Upper sensor, wind speed vector average(up_spd_vec_avg)
• Upper sensor, wind speed standard deviation(up_spd_sd)