Data Quality Reports for Session: 109677 User: jean1charl Completed: 01/04/2008


TABLE OF CONTENTS

DQR IDSubjectData Streams Affected
D030528.1TWP/MPL/C2 - Power outage in I-Van resulted in Missing DatatwpmplC2.00, twpmplC2.a1, twpmplcmask1clothC2.c1, twpmplsmask1clothC2.c1
D040424.2TWP/MPL/C2 - Sun-shade dropping during daytimetwpmplC2.00, twpmplC2.a1, twpmplcmask1clothC2.c1, twpmplsmask1clothC2.c1
D051028.4TWP/MPL/C2 - Reprocess: Global metadata errortwpmplC2.a1
D060621.2TWP/MPL/C2 - Optical throughput unacceptabletwpmplC2.00, twpmplC2.a1


DQRID : D030528.1
Start DateStart TimeEnd DateEnd Time
05/24/2003230005/25/20030010
Subject:
TWP/MPL/C2 - Power outage in I-Van resulted in Missing Data
DataStreams:twpmplC2.00, twpmplC2.a1, twpmplcmask1clothC2.c1, twpmplsmask1clothC2.c1
Description:
I forgot to put in the daily report that we took the I van down yesterday to replace the 
fans
in the Clary UPS. This was from 2300z on 24May03 to 0010z on 25May03. Instruments affected 
:

MPL
Ceilometer
MWR
WSI
TSI

Rex
Measurements:twpmplsmask1clothC2.c1:
  • Time offset of tweaks from base_time(time_offset)
  • base time(base_time)
  • MPL Cloth et al. Algorithm Significance Mask(SigniMaskMplCloth)
  • Height of Center of Each Range Bin(Heights)

twpmplC2.00:
  • Raw data stream - documentation not supported(Raw data stream - documentation not supported)

twpmplC2.a1:
  • time(time)
  • Laser Temperature(laser_temp)
  • Repetition rate, or Trigger Frequency of the laser(trigger_freq)
  • Maximum altitude retrieved from multichannel scalar card.(max_altitude)
  • Sum of raw backscatter counts per bin prior to ANY corrections.(total_counts)
  • Time in nanoseconds for each range bin of multichannel scalar card.(range_bin_time)
  • Angle of inclination with respect to horizontal(transceiver_altitude_angle)
  • Background Signal(background_signal)
  • Laser output energy per pulse(energy_monitor)
  • Number of laser shots recorded(shots_summed)
  • Angle of orientation with respect to true geographic north(transceiver_azimuth_angle)
  • Voltage level which operates the A/D card and the detector(voltage_05)
  • Amount of time laser pulse lags behind the scalar trigger(laser_scalar_sync_offset)
  • Time offset of tweaks from base_time(time_offset)
  • Voltage level which operates the thermistor(voltage_10)
  • lon(lon)
  • base time(base_time)
  • lat(lat)
  • Width of range-bins calculated from range_bin_time(range_bin_width)
  • Dummy altitude for Zeb(alt)
  • required to correct raw counts for detector deadtime prior to all other
    corrections.(deadtime_correction)
  • Amount of time the scalar lags behind the sync trigger(scalar_sync_offset)
  • Distance from leading edge of first range bin to the center of each bin .(range_bins)
  • Aerosol backscatter coefficient at 355 nm(backscatter)
  • Preliminary cloud base height(preliminary_cbh)
  • Number of laser pulses summed during measurement interval(shots_sum)
  • Array of heights for the range gates(height)
  • Detector Temperature(detector_temp)
  • Instrument Temperature(instrument_temp)
  • range(range)
  • Repetition Rate, or Trigger Frequency of the laser(pulse_rep)
  • Voltage level which operates the energy monitor(voltage_15)
  • Filter Temperature(filter_temp)
  • effective range offset due to poor sync between laser firing and A/D trigger.(range_offset)
  • value represents date of last configuration change as yyyymmdd(property)
  • Amount of time the actual laser pulse lags behind the sync trigger(laser_sync_offset)

twpmplcmask1clothC2.c1:
  • MPL Cloth et al. Algorithm Cloud Mask(CloudMaskMplCloth)
  • Height of Center of Each Range Bin(Heights)
  • base time(base_time)
  • Time offset of tweaks from base_time(time_offset)


Back To Table of Contents

DQRID : D040424.2
Start DateStart TimeEnd DateEnd Time
09/15/2003000010/11/20032359
Subject:
TWP/MPL/C2 - Sun-shade dropping during daytime
DataStreams:twpmplC2.00, twpmplC2.a1, twpmplcmask1clothC2.c1, twpmplsmask1clothC2.c1
Description:
The MPL sunshade began to act erratically on 9/15/2003 dropping frequently throughout day 
and night.  To reduce data loss, the sunshade was restrained from blocking the MPL during 
the night.  Thus, cloud detection during the night is satisfactory, but daytime 
measurements are frequently interspersed with episodes of beam-block.
Measurements:twpmplsmask1clothC2.c1:
  • Time offset of tweaks from base_time(time_offset)
  • base time(base_time)
  • MPL Cloth et al. Algorithm Significance Mask(SigniMaskMplCloth)
  • Height of Center of Each Range Bin(Heights)

twpmplC2.00:
  • Raw data stream - documentation not supported(Raw data stream - documentation not supported)

twpmplC2.a1:
  • time(time)
  • Laser Temperature(laser_temp)
  • Repetition rate, or Trigger Frequency of the laser(trigger_freq)
  • Maximum altitude retrieved from multichannel scalar card.(max_altitude)
  • Sum of raw backscatter counts per bin prior to ANY corrections.(total_counts)
  • Time in nanoseconds for each range bin of multichannel scalar card.(range_bin_time)
  • Angle of inclination with respect to horizontal(transceiver_altitude_angle)
  • Background Signal(background_signal)
  • Laser output energy per pulse(energy_monitor)
  • Number of laser shots recorded(shots_summed)
  • Angle of orientation with respect to true geographic north(transceiver_azimuth_angle)
  • Voltage level which operates the A/D card and the detector(voltage_05)
  • Amount of time laser pulse lags behind the scalar trigger(laser_scalar_sync_offset)
  • Time offset of tweaks from base_time(time_offset)
  • Voltage level which operates the thermistor(voltage_10)
  • lon(lon)
  • base time(base_time)
  • lat(lat)
  • Width of range-bins calculated from range_bin_time(range_bin_width)
  • Dummy altitude for Zeb(alt)
  • required to correct raw counts for detector deadtime prior to all other
    corrections.(deadtime_correction)
  • Amount of time the scalar lags behind the sync trigger(scalar_sync_offset)
  • Distance from leading edge of first range bin to the center of each bin .(range_bins)
  • Aerosol backscatter coefficient at 355 nm(backscatter)
  • Preliminary cloud base height(preliminary_cbh)
  • Number of laser pulses summed during measurement interval(shots_sum)
  • Array of heights for the range gates(height)
  • Detector Temperature(detector_temp)
  • Instrument Temperature(instrument_temp)
  • range(range)
  • Repetition Rate, or Trigger Frequency of the laser(pulse_rep)
  • Voltage level which operates the energy monitor(voltage_15)
  • Filter Temperature(filter_temp)
  • effective range offset due to poor sync between laser firing and A/D trigger.(range_offset)
  • value represents date of last configuration change as yyyymmdd(property)
  • Amount of time the actual laser pulse lags behind the sync trigger(laser_sync_offset)

twpmplcmask1clothC2.c1:
  • MPL Cloth et al. Algorithm Cloud Mask(CloudMaskMplCloth)
  • Height of Center of Each Range Bin(Heights)
  • base time(base_time)
  • Time offset of tweaks from base_time(time_offset)


Back To Table of Contents

DQRID : D051028.4
Start DateStart TimeEnd DateEnd Time
11/06/1998053807/08/20030731
Subject:
TWP/MPL/C2 - Reprocess: Global metadata error
DataStreams:twpmplC2.a1
Description:
During the time period specified, the global metadata attribute "averaging_int" is 
reported as 30 seconds when the value for this attribute should be 60 seconds.
Measurements:twpmplC2.a1:
  • Time offset of tweaks from base_time(time_offset)


Back To Table of Contents

DQRID : D060621.2
Start DateStart TimeEnd DateEnd Time
02/01/2003000011/12/20041900
Subject:
TWP/MPL/C2 - Optical throughput unacceptable
DataStreams:twpmplC2.00, twpmplC2.a1
Description:
The optical throughput of the MPL at Nauru is below an acceptable level. Despite an 
extended stay to address the problem in Feb 2003, the problem was unresolved.  An additional 
repair was attempted in July 2003 with no significant success.  Several optical components 
were replaced and the system was repeatedly re-aligned.  

The system appears to have been properly collimated as the shape of the signal is 
appropriate for both near and far range.  The magnitude of the signal was simply too low.  This 
signal decrease was apparent in ambient background values as well as from atmospheric 
signal, so the impact on data quality was not as severe as might otherwise be the case.  The 
MPL was still capable of detecting high altitude cirrus (day and night) but the 
sensitivity was reduced.
Measurements:twpmplC2.00:
  • Raw data stream - documentation not supported(Raw data stream - documentation not supported)

twpmplC2.a1:
  • Attenuated backscatter(detector_counts)


Back To Table of Contents



END OF DATA